2 Ton Scissor Floor Jack for Car/Travel Trailer/Truck/SUV/UTV With Speed Handle Floor Jack Steel

$24.14

The scissor jack, with tooth gears, can extend from 90mm(close position) to 360mm, more than enough to lift most vehicles.
Easy to operate using the chromed crank with speed handle.
Suitable for small and medium sized vehicles. Such as: For Buick, Santana, Vietnam and other

Description

Description:
1. The scissor jack, with tooth gears, can extend from 90mm(close position) to 360mm, more than enough to lift most vehicles.
2. Easy to operate using the chromed crank with speed handle.
3. Minimum height: about 90MM
4. Maximum height: approximately 360MM
5. Lifting: 2T
6. Color: Black
7. Material: Steel
8. Net weight: 2.1KG
9. Item Size: 35*8.5*8.5CM(13.78” * 3.35” * 3.35”)
10. Scope: Suitable for small and medium sized vehicles.

Package included:
Scissor jack * 1
Handle * 1

HEIGHT/CAPACITY CURVE
This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position.

Before Use
1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts.
2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock.
3. If the jack is found to be damaged, it should be removed from service until properly repaired.

OPERATING INSTRUCTIONS
1. Insert the jack handle into the hole of the handle socket.
2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket.
3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise.
4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly.

CARE AND MAINTENANCE
1. When jack is not in use, lifting arm should be in full down position.
2. Always keep jack clean and keep the screw and bearings well lubricated.
3. Store the handle with care.
The scissor jack, with tooth gears, can extend from 90mm(close position) to 360mm, more than enough to lift most vehicles.
Easy to operate using the chromed crank with speed handle.
Suitable for small and medium sized vehicles. Such as: For Buick, Santana, Vietnam and other
Condition: Brand new; Steel.
We Are The Factory Who Specialize In Producing The Car Accesories Many Years! High Quality & Good Service!With 2 Years Warranty and Friendly, Easy-to-Reach Support. Buy with Confidence!

Additional information

Brand

EAN

EANList

Label

Manufacturer

ManufacturerPartsWarrantyDescription

MPN

PackageQuantity

PartNumber

ProductGroup

Publisher

Studio

UPC

UPCList

Reviews

There are no reviews yet.

Be the first to review “2 Ton Scissor Floor Jack for Car/Travel Trailer/Truck/SUV/UTV With Speed Handle Floor Jack Steel”

Your email address will not be published. Required fields are marked *